Aku shaper set nose and tail rocker3/18/2023 If you are not going to spend the time making a cardboard or masonite template, s buffer all the components of the template and cut the sections. TRACKING THE OUTLINE ON THE BLANK: The outline is the outline of your board. If you have opted for the insertion of the stringer in EPS blocks, the following steps, the Outline and the Rocker Profile can be reversed. Once you have found the right position, let it dry well. The ideal solution would be to get one-handed screw clamps, or even carpenter's clamps with at least 600mm of opening. It is also possible to use numerous snap straps, paying attention to the sliding of the edges. Large weights can be achieved with many types of objects, from books to bricks to gym weights. Once you have aligned the blocks with each other, you will have to press everything, so that each element is well adherent to the other, and perfectly in line. With epoxy glue, you can do the entire bonding in one step. Wait half an hour, the time necessary for the stringer not to slide easily on the blank, and you will place the other block of EPS, also perfectly aligned on the stringer. Using weights, evenly press the stringer to the block. If you have opted for a vinyl glue or epoxy resin, I recommend a double step: take the stringer and place it perfectly aligned on the track you have previously marked. With a brush, spread it trying to stay inside on each edge of about 1cm / 1.5cm to prevent the glue from coming out of shape during pressure. Next take your glue, being careful not to overdo it to prevent it from falling on the sides of the blank that you will have to shape. In this way you will reproduce a blank similar to the PU, which you will go to work again later by tracing the rocker profile on the sides, which we will explain later. You can choose to stay 2/5 mm away from the line, both at the top and at the bottom, if you are not sure if you can do a precision job in the next step. With a file, or with a surform plane or a medium / coarse sandpaper, depending on how far you are from the line that represents your project, approach until you reach the goal. With a jigsaw, stand slightly off the line by securely fixing the model to the bench to keep it from vibrating. Trace the profile of the stringer on the wooden panel. Better if you build yourself a masonite template as we have explained previously, or cut out the design and glue it with a glue stick on the wood you have purchased. Print your rocker profile, using a plotter or glue by joining the various printed sheets precisely following the guidelines. There are several techniques, we point out one: If, on the other hand, you have opted for carbon or other special fabrics, following our advice, or you have got yourself a beautiful PU blank, you can skip this step.Īs a glue you can use a vinyl, an epoxy glue or even the epoxy resin that you have available for the table. First of all, if you have chosen a polystyrene block and want to insert a stringer, you will have to start from here. L the first phase of the actual work will be to give the final shape to your blank or polystyrene block, that is to say "shape" your table.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |